Power Feed - Knee, Table, and Cross Feeds

• Full wave SCR/DC Motor (similar to the Servo Type 150 Power Feed)
• Electro-Mechanical Clutch
• Reverse direction without waiting for complete stop
• Limits torque to 140 in-lb protecting nylon gear from breakage
• Eliminates over travel due to inertia of motor when contacting limit stops or loss of power
• Electro-Mechanical Clutch and full wave SCR circuit allows superior cutting at low speeds
• Jog switch
• Make incremental moves; length adjustable determined by speed control setting
• Limit switch
• Fluid protective cover
• Control panel fluid protective lip helps minimize coolant damage to all front control switches
• Helical gear provides the smoothest, quietest operation available
• Torque: 140in-lb peak / 100in-lb continuous
• Feed rate: 0.4 to 37.4 IPM

NOTE: Servo Products Company has made every effort to provide mounting hardware kits that are as accurate and complete as possible for each machine model. However, machine builders may change their designs without letting us know. Therefore, some kits may not fit properly. Please let us know when this happens. The following Documents are Adobe Acrobat PDF files. Click here for a free copy of Acrobat Reader.

Knee Feeds Note - Various mills such as the Bridgeport Series II, Lagun FTV3 and Deluxe, Alliant RT4V and other large mills are too heavy to lift with a Dynamo Knee Feed. Use a Type 200 or a Type 350X for heavy knees.